#define E1000_CTRL_SPD_1000 0x00000200 /* Force 1Gb */
#define E1000_CTRL_FRCSPD 0x00000800 /* Force Speed */
#define E1000_CTRL_FRCDPX 0x00001000 /* Force Duplex */
+#define E1000_CTRL_LANPHYPC_OVERRIDE 0x00010000 /* SW control of LANPHYPC */
+#define E1000_CTRL_LANPHYPC_VALUE 0x00020000 /* SW value of LANPHYPC */
#define E1000_CTRL_SWDPIN0 0x00040000 /* SWDPIN 0 value */
#define E1000_CTRL_SWDPIN1 0x00080000 /* SWDPIN 1 value */
#define E1000_CTRL_SWDPIO0 0x00400000 /* SWDPIN 0 Input or output */
#define E1000_ICH_FWSM_RSPCIPHY 0x00000040 /* Reset PHY on PCI Reset */
+/* FW established a valid mode */
+#define E1000_ICH_FWSM_FW_VALID 0x00008000
#define E1000_ICH_MNG_IAMT_MODE 0x2
static s32 e1000_init_phy_params_pchlan(struct e1000_hw *hw)
{
struct e1000_phy_info *phy = &hw->phy;
+ u32 ctrl;
s32 ret_val = 0;
phy->addr = 1;
phy->ops.power_down = e1000_power_down_phy_copper_ich8lan;
phy->autoneg_mask = AUTONEG_ADVERTISE_SPEED_DEFAULT;
+ if (!(er32(FWSM) & E1000_ICH_FWSM_FW_VALID)) {
+ /*
+ * The MAC-PHY interconnect may still be in SMBus mode
+ * after Sx->S0. Toggle the LANPHYPC Value bit to force
+ * the interconnect to PCIe mode, but only if there is no
+ * firmware present otherwise firmware will have done it.
+ */
+ ctrl = er32(CTRL);
+ ctrl |= E1000_CTRL_LANPHYPC_OVERRIDE;
+ ctrl &= ~E1000_CTRL_LANPHYPC_VALUE;
+ ew32(CTRL, ctrl);
+ udelay(10);
+ ctrl &= ~E1000_CTRL_LANPHYPC_OVERRIDE;
+ ew32(CTRL, ctrl);
+ msleep(50);
+ }
+
phy->id = e1000_phy_unknown;
ret_val = e1000e_get_phy_id(hw);
if (ret_val)