qlge: Fix EEH handling.
authorRon Mercer <ron.mercer@qlogic.com>
Wed, 28 Oct 2009 08:39:20 +0000 (08:39 +0000)
committerDavid S. Miller <davem@davemloft.net>
Thu, 29 Oct 2009 08:17:14 +0000 (01:17 -0700)
Clean up driver resources without touch the hardware. Add pci
save/restore state.

Signed-off-by: Ron Mercer <ron.mercer@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/qlge/qlge_main.c

index 48b45df85ec925c0feb479d3ba23862f49cc5ed3..cea7531f4f407d7a2a1542750142d2fa95f17fb1 100644 (file)
@@ -3916,6 +3916,7 @@ static int __devinit ql_init_device(struct pci_dev *pdev,
                goto err_out;
        }
 
+       pci_save_state(pdev);
        qdev->reg_base =
            ioremap_nocache(pci_resource_start(pdev, 1),
                            pci_resource_len(pdev, 1));
@@ -4070,6 +4071,33 @@ static void __devexit qlge_remove(struct pci_dev *pdev)
        free_netdev(ndev);
 }
 
+/* Clean up resources without touching hardware. */
+static void ql_eeh_close(struct net_device *ndev)
+{
+       int i;
+       struct ql_adapter *qdev = netdev_priv(ndev);
+
+       if (netif_carrier_ok(ndev)) {
+               netif_carrier_off(ndev);
+               netif_stop_queue(ndev);
+       }
+
+       if (test_bit(QL_ADAPTER_UP, &qdev->flags))
+               cancel_delayed_work_sync(&qdev->asic_reset_work);
+       cancel_delayed_work_sync(&qdev->mpi_reset_work);
+       cancel_delayed_work_sync(&qdev->mpi_work);
+       cancel_delayed_work_sync(&qdev->mpi_idc_work);
+       cancel_delayed_work_sync(&qdev->mpi_port_cfg_work);
+
+       for (i = 0; i < qdev->rss_ring_count; i++)
+               netif_napi_del(&qdev->rx_ring[i].napi);
+
+       clear_bit(QL_ADAPTER_UP, &qdev->flags);
+       ql_tx_ring_clean(qdev);
+       ql_free_rx_buffers(qdev);
+       ql_release_adapter_resources(qdev);
+}
+
 /*
  * This callback is called by the PCI subsystem whenever
  * a PCI bus error is detected.
@@ -4078,17 +4106,21 @@ static pci_ers_result_t qlge_io_error_detected(struct pci_dev *pdev,
                                               enum pci_channel_state state)
 {
        struct net_device *ndev = pci_get_drvdata(pdev);
-       struct ql_adapter *qdev = netdev_priv(ndev);
-
-       netif_device_detach(ndev);
 
-       if (state == pci_channel_io_perm_failure)
+       switch (state) {
+       case pci_channel_io_normal:
+               return PCI_ERS_RESULT_CAN_RECOVER;
+       case pci_channel_io_frozen:
+               netif_device_detach(ndev);
+               if (netif_running(ndev))
+                       ql_eeh_close(ndev);
+               pci_disable_device(pdev);
+               return PCI_ERS_RESULT_NEED_RESET;
+       case pci_channel_io_perm_failure:
+               dev_err(&pdev->dev,
+                       "%s: pci_channel_io_perm_failure.\n", __func__);
                return PCI_ERS_RESULT_DISCONNECT;
-
-       if (netif_running(ndev))
-               ql_adapter_down(qdev);
-
-       pci_disable_device(pdev);
+       }
 
        /* Request a slot reset. */
        return PCI_ERS_RESULT_NEED_RESET;
@@ -4105,25 +4137,15 @@ static pci_ers_result_t qlge_io_slot_reset(struct pci_dev *pdev)
        struct net_device *ndev = pci_get_drvdata(pdev);
        struct ql_adapter *qdev = netdev_priv(ndev);
 
+       pdev->error_state = pci_channel_io_normal;
+
+       pci_restore_state(pdev);
        if (pci_enable_device(pdev)) {
                QPRINTK(qdev, IFUP, ERR,
                        "Cannot re-enable PCI device after reset.\n");
                return PCI_ERS_RESULT_DISCONNECT;
        }
-
        pci_set_master(pdev);
-
-       netif_carrier_off(ndev);
-       ql_adapter_reset(qdev);
-
-       /* Make sure the EEPROM is good */
-       memcpy(ndev->perm_addr, ndev->dev_addr, ndev->addr_len);
-
-       if (!is_valid_ether_addr(ndev->perm_addr)) {
-               QPRINTK(qdev, IFUP, ERR, "After reset, invalid MAC address.\n");
-               return PCI_ERS_RESULT_DISCONNECT;
-       }
-
        return PCI_ERS_RESULT_RECOVERED;
 }
 
@@ -4131,17 +4153,21 @@ static void qlge_io_resume(struct pci_dev *pdev)
 {
        struct net_device *ndev = pci_get_drvdata(pdev);
        struct ql_adapter *qdev = netdev_priv(ndev);
+       int err = 0;
 
-       pci_set_master(pdev);
-
+       if (ql_adapter_reset(qdev))
+               QPRINTK(qdev, DRV, ERR, "reset FAILED!\n");
        if (netif_running(ndev)) {
-               if (ql_adapter_up(qdev)) {
+               err = qlge_open(ndev);
+               if (err) {
                        QPRINTK(qdev, IFUP, ERR,
                                "Device initialization failed after reset.\n");
                        return;
                }
+       } else {
+               QPRINTK(qdev, IFUP, ERR,
+                       "Device was not running prior to EEH.\n");
        }
-
        netif_device_attach(ndev);
 }