if (err) {
if (adapter->have_msi)
pci_disable_msi(adapter->pdev);
- DPRINTK(PROBE, ERR,
- "Unable to allocate interrupt Error: %d\n", err);
+ netif_err(adapter, probe, adapter->netdev,
+ "Unable to allocate interrupt Error: %d\n", err);
return err;
}
ixgb_adapter_stop(hw);
if (!ixgb_init_hw(hw))
- DPRINTK(PROBE, ERR, "ixgb_init_hw failed.\n");
+ netif_err(adapter, probe, adapter->netdev, "ixgb_init_hw failed\n");
/* restore frame size information */
IXGB_WRITE_REG(hw, MFS, hw->max_frame_size << IXGB_MFS_SHIFT);
/* make sure the EEPROM is good */
if (!ixgb_validate_eeprom_checksum(&adapter->hw)) {
- DPRINTK(PROBE, ERR, "The EEPROM Checksum Is Not Valid\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "The EEPROM Checksum Is Not Valid\n");
err = -EIO;
goto err_eeprom;
}
memcpy(netdev->perm_addr, netdev->dev_addr, netdev->addr_len);
if (!is_valid_ether_addr(netdev->perm_addr)) {
- DPRINTK(PROBE, ERR, "Invalid MAC Address\n");
+ netif_err(adapter, probe, adapter->netdev, "Invalid MAC Address\n");
err = -EIO;
goto err_eeprom;
}
/* carrier off reporting is important to ethtool even BEFORE open */
netif_carrier_off(netdev);
- DPRINTK(PROBE, INFO, "Intel(R) PRO/10GbE Network Connection\n");
+ netif_info(adapter, probe, adapter->netdev,
+ "Intel(R) PRO/10GbE Network Connection\n");
ixgb_check_options(adapter);
/* reset the hardware with the new settings */
hw->max_frame_size = netdev->mtu + ENET_HEADER_SIZE + ENET_FCS_LENGTH;
adapter->rx_buffer_len = hw->max_frame_size + 8; /* + 8 for errata */
- if ((hw->device_id == IXGB_DEVICE_ID_82597EX)
- || (hw->device_id == IXGB_DEVICE_ID_82597EX_CX4)
- || (hw->device_id == IXGB_DEVICE_ID_82597EX_LR)
- || (hw->device_id == IXGB_DEVICE_ID_82597EX_SR))
+ if ((hw->device_id == IXGB_DEVICE_ID_82597EX) ||
+ (hw->device_id == IXGB_DEVICE_ID_82597EX_CX4) ||
+ (hw->device_id == IXGB_DEVICE_ID_82597EX_LR) ||
+ (hw->device_id == IXGB_DEVICE_ID_82597EX_SR))
hw->mac_type = ixgb_82597;
else {
/* should never have loaded on this device */
- DPRINTK(PROBE, ERR, "unsupported device id\n");
+ netif_err(adapter, probe, adapter->netdev, "unsupported device id\n");
}
/* enable flow control to be programmed */
size = sizeof(struct ixgb_buffer) * txdr->count;
txdr->buffer_info = vmalloc(size);
if (!txdr->buffer_info) {
- DPRINTK(PROBE, ERR,
- "Unable to allocate transmit descriptor ring memory\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "Unable to allocate transmit descriptor ring memory\n");
return -ENOMEM;
}
memset(txdr->buffer_info, 0, size);
txdr->desc = pci_alloc_consistent(pdev, txdr->size, &txdr->dma);
if (!txdr->desc) {
vfree(txdr->buffer_info);
- DPRINTK(PROBE, ERR,
- "Unable to allocate transmit descriptor memory\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "Unable to allocate transmit descriptor memory\n");
return -ENOMEM;
}
memset(txdr->desc, 0, txdr->size);
size = sizeof(struct ixgb_buffer) * rxdr->count;
rxdr->buffer_info = vmalloc(size);
if (!rxdr->buffer_info) {
- DPRINTK(PROBE, ERR,
- "Unable to allocate receive descriptor ring\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "Unable to allocate receive descriptor ring\n");
return -ENOMEM;
}
memset(rxdr->buffer_info, 0, size);
if (!rxdr->desc) {
vfree(rxdr->buffer_info);
- DPRINTK(PROBE, ERR,
- "Unable to allocate receive descriptors\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "Unable to allocate receive descriptors\n");
return -ENOMEM;
}
memset(rxdr->desc, 0, rxdr->size);
/* MTU < 68 is an error for IPv4 traffic, just don't allow it */
if ((new_mtu < 68) ||
(max_frame > IXGB_MAX_JUMBO_FRAME_SIZE + ENET_FCS_LENGTH)) {
- DPRINTK(PROBE, ERR, "Invalid MTU setting %d\n", new_mtu);
+ netif_err(adapter, probe, adapter->netdev,
+ "Invalid MTU setting %d\n", new_mtu);
return -EINVAL;
}
&& !(IXGB_READ_REG(&adapter->hw, STATUS) &
IXGB_STATUS_TXOFF)) {
/* detected Tx unit hang */
- DPRINTK(DRV, ERR, "Detected Tx Unit Hang\n"
- " TDH <%x>\n"
- " TDT <%x>\n"
- " next_to_use <%x>\n"
- " next_to_clean <%x>\n"
- "buffer_info[next_to_clean]\n"
- " time_stamp <%lx>\n"
- " next_to_watch <%x>\n"
- " jiffies <%lx>\n"
- " next_to_watch.status <%x>\n",
- IXGB_READ_REG(&adapter->hw, TDH),
- IXGB_READ_REG(&adapter->hw, TDT),
- tx_ring->next_to_use,
- tx_ring->next_to_clean,
- tx_ring->buffer_info[eop].time_stamp,
- eop,
- jiffies,
- eop_desc->status);
+ netif_err(adapter, drv, adapter->netdev,
+ "Detected Tx Unit Hang\n"
+ " TDH <%x>\n"
+ " TDT <%x>\n"
+ " next_to_use <%x>\n"
+ " next_to_clean <%x>\n"
+ "buffer_info[next_to_clean]\n"
+ " time_stamp <%lx>\n"
+ " next_to_watch <%x>\n"
+ " jiffies <%lx>\n"
+ " next_to_watch.status <%x>\n",
+ IXGB_READ_REG(&adapter->hw, TDH),
+ IXGB_READ_REG(&adapter->hw, TDT),
+ tx_ring->next_to_use,
+ tx_ring->next_to_clean,
+ tx_ring->buffer_info[eop].time_stamp,
+ eop,
+ jiffies,
+ eop_desc->status);
netif_stop_queue(netdev);
}
}
struct ixgb_adapter *adapter = netdev_priv(netdev);
if (pci_enable_device(pdev)) {
- DPRINTK(PROBE, ERR, "Cannot re-enable PCI device after reset.\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "Cannot re-enable PCI device after reset\n");
return PCI_ERS_RESULT_DISCONNECT;
}
/* Make sure the EEPROM is good */
if (!ixgb_validate_eeprom_checksum(&adapter->hw)) {
- DPRINTK(PROBE, ERR, "After reset, the EEPROM checksum is not valid.\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "After reset, the EEPROM checksum is not valid\n");
return PCI_ERS_RESULT_DISCONNECT;
}
ixgb_get_ee_mac_addr(&adapter->hw, netdev->dev_addr);
memcpy(netdev->perm_addr, netdev->dev_addr, netdev->addr_len);
if (!is_valid_ether_addr(netdev->perm_addr)) {
- DPRINTK(PROBE, ERR, "After reset, invalid MAC address.\n");
+ netif_err(adapter, probe, adapter->netdev,
+ "After reset, invalid MAC address\n");
return PCI_ERS_RESULT_DISCONNECT;
}