EXTVBUS programming is required by OMAP3EVM REV >=E to supply 500mA
power so adding a flag which can be used by musb driver to program
EXTVBUS.
Signed-off-by: Ajay Kumar Gupta <ajay.gupta@ti.com>
Signed-off-by: Felipe Balbi <felipe.balbi@nokia.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
omap_mux_init_gpio(21, OMAP_PIN_INPUT_PULLUP);
ehci_pdata.reset_gpio_port[1] = 21;
+ /* EVM REV >= E can supply 500mA with EXTVBUS programming */
+ musb_board_data.power = 500;
+ musb_board_data.extvbus = 1;
} else {
/* setup EHCI phy reset on MDC */
omap_mux_init_gpio(135, OMAP_PIN_OUTPUT);
musb_plat.board_data = board_data;
musb_plat.power = board_data->power >> 1;
musb_plat.mode = board_data->mode;
+ musb_plat.extvbus = board_data->extvbus;
if (platform_device_register(&musb_device) < 0)
printk(KERN_ERR "Unable to register HS-USB (MUSB) device\n");
u8 interface_type;
u8 mode;
u16 power;
+ unsigned extvbus:1;
};
enum musb_interface {MUSB_INTERFACE_ULPI, MUSB_INTERFACE_UTMI};