tg3: Convert PHY_ADDR => TG3_PHY_MII_ADDR
authorMatt Carlson <mcarlson@broadcom.com>
Mon, 2 Nov 2009 14:24:36 +0000 (14:24 +0000)
committerDavid S. Miller <davem@davemloft.net>
Tue, 3 Nov 2009 07:39:01 +0000 (23:39 -0800)
This patch renames the PHY_ADDR preprocessor definition.  The following
patch will identify a new member on the MDIO bus, so we want this
preprocessor definition to be a little more descriptive.

Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/tg3.c
drivers/net/tg3.h

index b3c5d74022f2a02786d02a9d258c937ecad5e91f..1c53250e4007a8497ebc73976468d36c95b4a13d 100644 (file)
@@ -937,7 +937,7 @@ static void tg3_mdio_config_5785(struct tg3 *tp)
        u32 val;
        struct phy_device *phydev;
 
-       phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+       phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
        switch (phydev->drv->phy_id & phydev->drv->phy_id_mask) {
        case TG3_PHY_ID_BCM50610:
                val = MAC_PHYCFG2_50610_LED_MODES;
@@ -1031,7 +1031,7 @@ static void tg3_mdio_start(struct tg3 *tp)
                if (is_serdes)
                        tp->phy_addr += 7;
        } else
-               tp->phy_addr = PHY_ADDR;
+               tp->phy_addr = TG3_PHY_MII_ADDR;
 
        if ((tp->tg3_flags3 & TG3_FLG3_MDIOBUS_INITED) &&
            GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5785)
@@ -1062,7 +1062,7 @@ static int tg3_mdio_init(struct tg3 *tp)
        tp->mdio_bus->read     = &tg3_mdio_read;
        tp->mdio_bus->write    = &tg3_mdio_write;
        tp->mdio_bus->reset    = &tg3_mdio_reset;
-       tp->mdio_bus->phy_mask = ~(1 << PHY_ADDR);
+       tp->mdio_bus->phy_mask = ~(1 << TG3_PHY_MII_ADDR);
        tp->mdio_bus->irq      = &tp->mdio_irq[0];
 
        for (i = 0; i < PHY_MAX_ADDR; i++)
@@ -1084,7 +1084,7 @@ static int tg3_mdio_init(struct tg3 *tp)
                return i;
        }
 
-       phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+       phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
        if (!phydev || !phydev->drv) {
                printk(KERN_WARNING "%s: No PHY devices\n", tp->dev->name);
@@ -1311,7 +1311,7 @@ static void tg3_setup_flow_control(struct tg3 *tp, u32 lcladv, u32 rmtadv)
        u32 old_tx_mode = tp->tx_mode;
 
        if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB)
-               autoneg = tp->mdio_bus->phy_map[PHY_ADDR]->autoneg;
+               autoneg = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]->autoneg;
        else
                autoneg = tp->link_config.autoneg;
 
@@ -1348,7 +1348,7 @@ static void tg3_adjust_link(struct net_device *dev)
        u8 oldflowctrl, linkmesg = 0;
        u32 mac_mode, lcl_adv, rmt_adv;
        struct tg3 *tp = netdev_priv(dev);
-       struct phy_device *phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+       struct phy_device *phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
        spin_lock_bh(&tp->lock);
 
@@ -1434,7 +1434,7 @@ static int tg3_phy_init(struct tg3 *tp)
        /* Bring the PHY back to a known state. */
        tg3_bmcr_reset(tp);
 
-       phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+       phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
        /* Attach the MAC to the PHY. */
        phydev = phy_connect(tp->dev, dev_name(&phydev->dev), tg3_adjust_link,
@@ -1461,7 +1461,7 @@ static int tg3_phy_init(struct tg3 *tp)
                                      SUPPORTED_Asym_Pause);
                break;
        default:
-               phy_disconnect(tp->mdio_bus->phy_map[PHY_ADDR]);
+               phy_disconnect(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
                return -EINVAL;
        }
 
@@ -1479,7 +1479,7 @@ static void tg3_phy_start(struct tg3 *tp)
        if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
                return;
 
-       phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+       phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
        if (tp->link_config.phy_is_low_power) {
                tp->link_config.phy_is_low_power = 0;
@@ -1499,13 +1499,13 @@ static void tg3_phy_stop(struct tg3 *tp)
        if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
                return;
 
-       phy_stop(tp->mdio_bus->phy_map[PHY_ADDR]);
+       phy_stop(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
 }
 
 static void tg3_phy_fini(struct tg3 *tp)
 {
        if (tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED) {
-               phy_disconnect(tp->mdio_bus->phy_map[PHY_ADDR]);
+               phy_disconnect(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
                tp->tg3_flags3 &= ~TG3_FLG3_PHY_CONNECTED;
        }
 }
@@ -2474,7 +2474,7 @@ static int tg3_set_power_state(struct tg3 *tp, pci_power_t state)
                        struct phy_device *phydev;
                        u32 phyid, advertising;
 
-                       phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+                       phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
                        tp->link_config.phy_is_low_power = 1;
 
@@ -9243,9 +9243,11 @@ static int tg3_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
        struct tg3 *tp = netdev_priv(dev);
 
        if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
+               struct phy_device *phydev;
                if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
                        return -EAGAIN;
-               return phy_ethtool_gset(tp->mdio_bus->phy_map[PHY_ADDR], cmd);
+               phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
+               return phy_ethtool_gset(phydev, cmd);
        }
 
        cmd->supported = (SUPPORTED_Autoneg);
@@ -9284,9 +9286,11 @@ static int tg3_set_settings(struct net_device *dev, struct ethtool_cmd *cmd)
        struct tg3 *tp = netdev_priv(dev);
 
        if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
+               struct phy_device *phydev;
                if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
                        return -EAGAIN;
-               return phy_ethtool_sset(tp->mdio_bus->phy_map[PHY_ADDR], cmd);
+               phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
+               return phy_ethtool_sset(phydev, cmd);
        }
 
        if (cmd->autoneg != AUTONEG_ENABLE &&
@@ -9469,7 +9473,7 @@ static int tg3_nway_reset(struct net_device *dev)
        if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
                if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
                        return -EAGAIN;
-               r = phy_start_aneg(tp->mdio_bus->phy_map[PHY_ADDR]);
+               r = phy_start_aneg(tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR]);
        } else {
                u32 bmcr;
 
@@ -9588,7 +9592,7 @@ static int tg3_set_pauseparam(struct net_device *dev, struct ethtool_pauseparam
                        u32 newadv;
                        struct phy_device *phydev;
 
-                       phydev = tp->mdio_bus->phy_map[PHY_ADDR];
+                       phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
 
                        if (epause->rx_pause) {
                                if (epause->tx_pause)
@@ -10568,9 +10572,11 @@ static int tg3_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd)
        int err;
 
        if (tp->tg3_flags3 & TG3_FLG3_USE_PHYLIB) {
+               struct phy_device *phydev;
                if (!(tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED))
                        return -EAGAIN;
-               return phy_mii_ioctl(tp->mdio_bus->phy_map[PHY_ADDR], data, cmd);
+               phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
+               return phy_mii_ioctl(phydev, data, cmd);
        }
 
        switch(cmd) {
@@ -14135,13 +14141,14 @@ static int __devinit tg3_init_one(struct pci_dev *pdev,
               tg3_bus_string(tp, str),
               dev->dev_addr);
 
-       if (tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED)
+       if (tp->tg3_flags3 & TG3_FLG3_PHY_CONNECTED) {
+               struct phy_device *phydev;
+               phydev = tp->mdio_bus->phy_map[TG3_PHY_MII_ADDR];
                printk(KERN_INFO
                       "%s: attached PHY driver [%s] (mii_bus:phy_addr=%s)\n",
-                      tp->dev->name,
-                      tp->mdio_bus->phy_map[PHY_ADDR]->drv->name,
-                      dev_name(&tp->mdio_bus->phy_map[PHY_ADDR]->dev));
-       else
+                      tp->dev->name, phydev->drv->name,
+                      dev_name(&phydev->dev));
+       } else
                printk(KERN_INFO
                       "%s: attached PHY is %s (%s Ethernet) (WireSpeed[%d])\n",
                       tp->dev->name, tg3_phy_string(tp),
index eb4ed82d71e0d5d156f5907dc51015c1f87932e6..40501cb3b359d7973d7d357addcff1a510a3a8cc 100644 (file)
 #define  NIC_SRAM_MBUF_POOL_SIZE5705   0x0000e000
 
 /* Currently this is fixed. */
-#define PHY_ADDR               0x01
+#define TG3_PHY_MII_ADDR               0x01
 
 /* Tigon3 specific PHY MII registers. */
 #define  TG3_BMCR_SPEED1000            0x0040