[NISTC_INT_CTRL_REG] = { 0x176, 2 },
[NISTC_AI_OUT_CTRL_REG] = { 0x178, 2 },
[NISTC_ATRIG_ETC_REG] = { 0x17a, 2 },
- [AI_START_STOP_Select_Register] = { 0x17c, 2 },
+ [NISTC_AI_START_STOP_REG] = { 0x17c, 2 },
[AI_Trigger_Select_Register] = { 0x17e, 2 },
[AI_DIV_Load_A_Register] = { 0x180, 4 },
[AO_Start_Select_Register] = { 0x184, 2 },
ni_stc_writew(dev, mode2, NISTC_AI_MODE2_REG);
if (cmd->chanlist_len == 1 || devpriv->is_611x || devpriv->is_6143) {
- start_stop_select |= AI_STOP_Polarity;
- start_stop_select |= AI_STOP_Select(31); /* logic low */
- start_stop_select |= AI_STOP_Sync;
+ /* logic low */
+ start_stop_select |= NISTC_AI_STOP_POLARITY |
+ NISTC_AI_STOP_SEL(31) |
+ NISTC_AI_STOP_SYNC;
} else {
- start_stop_select |= AI_STOP_Select(19); /* ai configuration memory */
+ /* ai configuration memory */
+ start_stop_select |= NISTC_AI_STOP_SEL(19);
}
- ni_stc_writew(dev, start_stop_select, AI_START_STOP_Select_Register);
+ ni_stc_writew(dev, start_stop_select, NISTC_AI_START_STOP_REG);
devpriv->ai_cmd2 = 0;
switch (cmd->stop_src) {
interrupt_a_enable |= AI_STOP_Interrupt_Enable;
/* this is required to get the last sample for chanlist_len > 1, not sure why */
if (cmd->chanlist_len > 1)
- start_stop_select |=
- AI_STOP_Polarity | AI_STOP_Edge;
+ start_stop_select |= NISTC_AI_STOP_POLARITY |
+ NISTC_AI_STOP_EDGE;
}
break;
case TRIG_NONE:
switch (cmd->scan_begin_src) {
case TRIG_TIMER:
/*
- stop bits for non 611x boards
- AI_SI_Special_Trigger_Delay=0
- NISTC_AI_MODE2_PRE_TRIGGER=0
- AI_START_STOP_Select_Register:
- AI_START_Polarity=0 (?) rising edge
- AI_START_Edge=1 edge triggered
- AI_START_Sync=1 (?)
- AI_START_Select=0 SI_TC
- AI_STOP_Polarity=0 rising edge
- AI_STOP_Edge=0 level
- AI_STOP_Sync=1
- AI_STOP_Select=19 external pin (configuration mem)
+ * stop bits for non 611x boards
+ * AI_SI_Special_Trigger_Delay=0
+ * NISTC_AI_MODE2_PRE_TRIGGER=0
+ * NISTC_AI_START_STOP_REG:
+ * NISTC_AI_START_POLARITY=0 (?) rising edge
+ * NISTC_AI_START_EDGE=1 edge triggered
+ * NISTC_AI_START_SYNC=1 (?)
+ * NISTC_AI_START_SEL=0 SI_TC
+ * NISTC_AI_STOP_POLARITY=0 rising edge
+ * NISTC_AI_STOP_EDGE=0 level
+ * NISTC_AI_STOP_SYNC=1
+ * NISTC_AI_STOP_SEL=19 external pin (configuration mem)
*/
- start_stop_select |= AI_START_Edge | AI_START_Sync;
- ni_stc_writew(dev, start_stop_select,
- AI_START_STOP_Select_Register);
+ start_stop_select |= NISTC_AI_START_EDGE | NISTC_AI_START_SYNC;
+ ni_stc_writew(dev, start_stop_select, NISTC_AI_START_STOP_REG);
mode2 &= ~NISTC_AI_MODE2_SI_INIT_LOAD_SRC; /* A */
mode2 |= NISTC_AI_MODE2_SI_RELOAD_MODE(0);
break;
case TRIG_EXT:
if (cmd->scan_begin_arg & CR_EDGE)
- start_stop_select |= AI_START_Edge;
- /* AI_START_Polarity==1 is falling edge */
- if (cmd->scan_begin_arg & CR_INVERT)
- start_stop_select |= AI_START_Polarity;
+ start_stop_select |= NISTC_AI_START_EDGE;
+ if (cmd->scan_begin_arg & CR_INVERT) /* falling edge */
+ start_stop_select |= NISTC_AI_START_POLARITY;
if (cmd->scan_begin_src != cmd->convert_src ||
(cmd->scan_begin_arg & ~CR_EDGE) !=
(cmd->convert_arg & ~CR_EDGE))
- start_stop_select |= AI_START_Sync;
+ start_stop_select |= NISTC_AI_START_SYNC;
start_stop_select |=
- AI_START_Select(1 + CR_CHAN(cmd->scan_begin_arg));
- ni_stc_writew(dev, start_stop_select,
- AI_START_STOP_Select_Register);
+ NISTC_AI_START_SEL(1 + CR_CHAN(cmd->scan_begin_arg));
+ ni_stc_writew(dev, start_stop_select, NISTC_AI_START_STOP_REG);
break;
}
#define NISTC_ATRIG_ETC_ENA BIT(3)
#define NISTC_ATRIG_ETC_MODE(x) (((x) & 0x7) << 0)
+#define NISTC_AI_START_STOP_REG 62
+#define NISTC_AI_START_POLARITY BIT(15)
+#define NISTC_AI_STOP_POLARITY BIT(14)
+#define NISTC_AI_STOP_SYNC BIT(13)
+#define NISTC_AI_STOP_EDGE BIT(12)
+#define NISTC_AI_STOP_SEL(x) (((x) & 0x1f) << 7)
+#define NISTC_AI_START_SYNC BIT(6)
+#define NISTC_AI_START_EDGE BIT(5)
+#define NISTC_AI_START_SEL(x) (((x) & 0x1f) << 0)
+
#define AI_Status_1_Register 2
#define Interrupt_A_St 0x8000
#define AI_FIFO_Full_St 0x4000
#define AO_BC_Save_Registers 18
#define AO_UC_Save_Registers 20
-#define AI_START_STOP_Select_Register 62
-#define AI_START_Polarity _bit15
-#define AI_STOP_Polarity _bit14
-#define AI_STOP_Sync _bit13
-#define AI_STOP_Edge _bit12
-#define AI_STOP_Select(a) (((a) & 0x1f)<<7)
-#define AI_START_Sync _bit6
-#define AI_START_Edge _bit5
-#define AI_START_Select(a) ((a) & 0x1f)
-
#define AI_Trigger_Select_Register 63
#define AI_START1_Polarity _bit15
#define AI_START2_Polarity _bit14