mmc: core: fix multi-bit bus width without high-speed mode

Commit 577fb13199b1 ("mmc: rework selection of bus speed mode")
refactored bus width selection code to mmc_select_bus_width().

However, it also altered the behavior to not call the selection code in
non-high-speed modes anymore.

This causes 1-bit mode to always be used when the high-speed mode is not
enabled, even though 4-bit and 8-bit bus are valid bus widths in the
backwards-compatibility (legacy) mode as well (see e.g. 5.3.2 Bus Speed
Modes in JEDEC 84-B50). This results in a significant regression in
transfer speeds.

Fix the code to allow 4-bit and 8-bit widths even without high-speed
mode, as before.

Tested with a Zynq-7000 PicoZed 7020 board.

Fixes: 577fb13199b1 ("mmc: rework selection of bus speed mode")
Signed-off-by: Anssi Hannula <anssi.hannula@bitwise.fi>
Cc: <stable@vger.kernel.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index b61b52f9da3d88bc1903e14ffc56dd276700c814..0fccca075e2947337cc999e04438b1c1e2cc056d 100644 (file)
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -1706,10 +1706,10 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
                err = mmc_select_hs400(card);
                if (err)
                        goto free_card;
-       } else if (mmc_card_hs(card)) {
+       } else {
                /* Select the desired bus width optionally */
                err = mmc_select_bus_width(card);
-               if (err > 0) {
+               if (err > 0 && mmc_card_hs(card)) {
                        err = mmc_select_hs_ddr(card);
                        if (err)
                                goto free_card;