Fix the following warnings from dtc by either adding or removing
the unit name from the node.
Warning (unit_address_vs_reg): Node /soc/flash-controller@
40003000/flash@0 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@0 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@1 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@2 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@3 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@4 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@5 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@6 has a unit name, but no reg property
Warning (unit_address_vs_reg): Node /pca_buttons/button@7 has a unit name, but no reg property
Signed-off-by: Joachim Eastwood <manabian@gmail.com>
poll-interval = <100>;
autorepeat;
- button@0 {
+ button0 {
label = "joy:right";
linux,code = <KEY_RIGHT>;
gpios = <&pca_gpio 8 GPIO_ACTIVE_LOW>;
};
- button@1 {
+ button1 {
label = "joy:up";
linux,code = <KEY_UP>;
gpios = <&pca_gpio 9 GPIO_ACTIVE_LOW>;
};
- button@2 {
+ button2 {
label = "joy:enter";
linux,code = <KEY_ENTER>;
gpios = <&pca_gpio 10 GPIO_ACTIVE_LOW>;
};
- button@3 {
+ button3 {
label = "joy:left";
linux,code = <KEY_LEFT>;
gpios = <&pca_gpio 11 GPIO_ACTIVE_LOW>;
};
- button@4 {
+ button4 {
label = "joy:down";
linux,code = <KEY_DOWN>;
gpios = <&pca_gpio 12 GPIO_ACTIVE_LOW>;
};
- button@5 {
+ button5 {
label = "user:sw3";
linux,code = <KEY_F1>;
gpios = <&pca_gpio 13 GPIO_ACTIVE_LOW>;
};
- button@6 {
+ button6 {
label = "user:sw4";
linux,code = <KEY_F2>;
gpios = <&pca_gpio 14 GPIO_ACTIVE_LOW>;
};
- button@7 {
+ button7 {
label = "user:sw5";
linux,code = <KEY_F3>;
gpios = <&pca_gpio 15 GPIO_ACTIVE_LOW>;
pinctrl-names = "default";
pinctrl-0 = <&spifi_pins>;
- flash@0 {
+ flash {
compatible = "jedec,spi-nor";
spi-rx-bus-width = <4>;
#address-cells = <1>;