dts: Add a binding for Synopsys emac max-frame-size

This change adds a parameter for the Synopsys 10/100/1000
stmmac Ethernet driver to configure the maximum frame
size supported by the EMAC driver. Synopsys allows the FIFO
sizes to be configured when the cores are built for a particular
device, but do not provide a way for the driver to read
information from the device about the maximum MTU size
supported as limited by the device's FIFO size.

Signed-off-by: Vince Bridgers <vbridgers2013@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
index aefb63949619eaeba843a64ca0f323fa6ba4164c..9d92d42140f22109143f9d975a9fd2c96fec9837 100644 (file)
--- a/Documentation/devicetree/bindings/net/stmmac.txt
+++ b/Documentation/devicetree/bindings/net/stmmac.txt
@@ -32,6 +32,8 @@ Optional properties:
 - resets: Should contain a phandle to the STMMAC reset signal, if any
 - reset-names: Should contain the reset signal name "stmmaceth", if a
        reset phandle is given
+- max-frame-size:      Maximum Transfer Unit (IEEE defined MTU), rather
+                       than the maximum frame size.
 
 Examples:
 
@@ -42,5 +44,6 @@ Examples:
                interrupts = <24 23>;
                interrupt-names = "macirq", "eth_wake_irq";
                mac-address = [000000000000]; /* Filled in by U-Boot */
+               max-frame-size = <3800>;
                phy-mode = "gmii";
        };