video: ARM CLCD: Fix calculation of bits-per-pixel
authorJon Medhurst (Tixy) <tixy@linaro.org>
Wed, 20 Aug 2014 12:41:04 +0000 (13:41 +0100)
committerTomi Valkeinen <tomi.valkeinen@ti.com>
Tue, 26 Aug 2014 09:50:27 +0000 (12:50 +0300)
If the device-tree specifies a max-memory-bandwidth property then the
CLCD driver uses that to calculate the bits-per-pixel supported,
however, this calculation is faulty for two reasons.

1. It doesn't ensure that the result is a sane value, i.e. a power of 2
   and <= 32 as the rest of the code assumes.

2. It uses the displayed resolution and calculates the average bandwidth
   across the whole frame. It should instead calculate the peak
   bandwidth based on the pixel clock.

This patch fixes both the above.

Signed-off-by: Jon Medhurst <tixy@linaro.org>
Acked-by: Pawel Moll <pawel.moll@arm.com>
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
drivers/video/fbdev/amba-clcd.c

index beadd3edaa176625aaeb47440a44b830e5c78fd4..a7b6217ac87b4086eae386ed6ebaafe9cf500481 100644 (file)
@@ -24,6 +24,7 @@
 #include <linux/list.h>
 #include <linux/amba/bus.h>
 #include <linux/amba/clcd.h>
+#include <linux/bitops.h>
 #include <linux/clk.h>
 #include <linux/hardirq.h>
 #include <linux/dma-mapping.h>
@@ -650,6 +651,7 @@ static int clcdfb_of_init_display(struct clcd_fb *fb)
 {
        struct device_node *endpoint;
        int err;
+       unsigned int bpp;
        u32 max_bandwidth;
        u32 tft_r0b0g0[3];
 
@@ -667,11 +669,22 @@ static int clcdfb_of_init_display(struct clcd_fb *fb)
 
        err = of_property_read_u32(fb->dev->dev.of_node, "max-memory-bandwidth",
                        &max_bandwidth);
-       if (!err)
-               fb->panel->bpp = 8 * max_bandwidth / (fb->panel->mode.xres *
-                               fb->panel->mode.yres * fb->panel->mode.refresh);
-       else
-               fb->panel->bpp = 32;
+       if (!err) {
+               /*
+                * max_bandwidth is in bytes per second and pixclock in
+                * pico-seconds, so the maximum allowed bits per pixel is
+                *   8 * max_bandwidth / (PICOS2KHZ(pixclock) * 1000)
+                * Rearrange this calculation to avoid overflow and then ensure
+                * result is a valid format.
+                */
+               bpp = max_bandwidth / (1000 / 8)
+                       / PICOS2KHZ(fb->panel->mode.pixclock);
+               bpp = rounddown_pow_of_two(bpp);
+               if (bpp > 32)
+                       bpp = 32;
+       } else
+               bpp = 32;
+       fb->panel->bpp = bpp;
 
 #ifdef CONFIG_CPU_BIG_ENDIAN
        fb->panel->cntl |= CNTL_BEBO;