USB: cypress_m8: unify confusing new baudrate check

The current code has a confusing duplicate new_baudrate init when setting
the serial parameters.  So just combine the if statement checks to avoid
this.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

diff --git a/drivers/usb/serial/cypress_m8.c b/drivers/usb/serial/cypress_m8.c
index 8c69bc53a083c8d19cf8b7934877dbad84c01988..47a18193abad7a88f3e5f9e0b504e068161db8ec 100644 (file)
--- a/drivers/usb/serial/cypress_m8.c
+++ b/drivers/usb/serial/cypress_m8.c
@@ -352,15 +352,12 @@ static int cypress_serial_control(struct tty_struct *tty,
 
        switch (cypress_request_type) {
        case CYPRESS_SET_CONFIG:
-               new_baudrate = priv->baud_rate;
                /* 0 means 'Hang up' so doesn't change the true bit rate */
-               if (baud_rate == 0)
-                       new_baudrate = priv->baud_rate;
-               /* Change of speed ? */
-               else if (baud_rate != priv->baud_rate) {
+               new_baudrate = priv->baud_rate;
+               if (baud_rate && baud_rate != priv->baud_rate) {
                        dbg("%s - baud rate is changing", __func__);
                        retval = analyze_baud_rate(port, baud_rate);
-                       if (retval >=  0) {
+                       if (retval >= 0) {
                                new_baudrate = retval;
                                dbg("%s - New baud rate set to %d",
                                    __func__, new_baudrate);