hpsa: change how SA controllers are reset

Change how SA controllers are reset by changing PCI power levels.
The hpsa driver was finding the PCI_PM_CTRL_STATE_MASK offset
then reading/writing a bitmask to change the power state. There
are kernel functions that do the same operations. Better to use
the kernel functions.

Signed-off-by: Don Brace <don.brace@pmcs.com>
Reviewed-by: Scott Teel <scott.teel@pmcs.com>
Reviewed-by: Webb Scales <webbnh@hp.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>

diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c
index 9edacff962a39ff95b4e6b15b96ac5992a16623e..371d0a81d5356d257c3b979d6e7fc3afc967bd19 100644 (file)
--- a/drivers/scsi/hpsa.c
+++ b/drivers/scsi/hpsa.c
@@ -5689,30 +5689,22 @@ static int hpsa_controller_hard_reset(struct pci_dev *pdev,
                 * the controller, place the interface device in D3 then to D0,
                 * this causes a secondary PCI reset which will reset the
                 * controller." */
-               int pos;
-               u16 pmcsr;
-
-               pos = pci_find_capability(pdev, PCI_CAP_ID_PM);
-               if (pos == 0) {
-                       dev_err(&pdev->dev,
-                               "hpsa_reset_controller: "
-                               "PCI PM not supported\n");
-                       return -ENODEV;
-               }
+
+               int rc = 0;
+
                dev_info(&pdev->dev, "using PCI PM to reset controller\n");
+
                /* enter the D3hot power management state */
-               pci_read_config_word(pdev, pos + PCI_PM_CTRL,
-                                       (__force u16 *)&pmcsr);
-               pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
-               pmcsr |= (__force u16) PCI_D3hot;
-               pci_write_config_word(pdev, pos + PCI_PM_CTRL, pmcsr);
+               rc = pci_set_power_state(pdev, PCI_D3hot);
+               if (rc)
+                       return rc;
 
                msleep(500);
 
                /* enter the D0 power management state */
-               pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
-               pmcsr |= (__force u16) PCI_D0;
-               pci_write_config_word(pdev, pos + PCI_PM_CTRL, pmcsr);
+               rc = pci_set_power_state(pdev, PCI_D0);
+               if (rc)
+                       return rc;
 
                /*
                 * The P600 requires a small delay when changing states.