Add devicetree binding documentation for the LTC2941/LTC2943 driver

This adds the devicetree binding documentation for the LTC2941 and LTC2943
driver. These are I2C connected battery gas gauge ICs.

Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Signed-off-by: Sebastian Reichel <sre@kernel.org>

diff --git a/Documentation/devicetree/bindings/power/ltc2941.txt b/Documentation/devicetree/bindings/power/ltc2941.txt
new file mode 100644 (file)
index 0000000..ea42ae1
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/ltc2941.txt
@@ -0,0 +1,27 @@
+binding for LTC2941 and LTC2943 battery gauges
+
+Both the LTC2941 and LTC2943 measure battery capacity.
+The LTC2943 is compatible with the LTC2941, it adds voltage and
+temperature monitoring, and uses a slightly different conversion
+formula for the charge counter.
+
+Required properties:
+- compatible: Should contain "ltc2941" or "ltc2943" which also indicates the
+    type of I2C chip attached.
+- reg: The 7-bit I2C address.
+- lltc,resistor-sense: The sense resistor value in milli-ohms. Can be a 32-bit
+    negative value when the battery has been connected to the wrong end of the
+    resistor.
+- lltc,prescaler-exponent: The prescaler exponent as explained in the datasheet.
+    This determines the range and accuracy of the gauge. The value is programmed
+    into the chip only if it differs from the current setting. The setting is
+    lost when the battery is disconnected.
+
+Example from the Topic Miami Florida board:
+
+       fuelgauge: ltc2943@64 {
+               compatible = "ltc2943";
+               reg = <0x64>;
+               lltc,resistor-sense = <15>;
+               lltc,prescaler-exponent = <5>; /* 2^(2*5) = 1024 */
+       };