pinctrl: dra: dt-bindings: Fix pull enable/disable

The DRA74/72 control module pins have a weak pull up and pull down.
This is configured by bit offset 17. if BIT(17) is 1, a pull up is
selected, else a pull down is selected.

However, this pull resisstor is applied based on BIT(16) -
PULLUDENABLE - if BIT(18) is *0*, then pull as defined in BIT(17) is
applied, else no weak pulls are applied. We defined this in reverse.

Reference: Table 18-5 (Description of the pad configuration register
bits) in Technical Reference Manual Revision (DRA74x revision Q:
SPRUHI2Q Revised June 2014 and DRA72x revision F: SPRUHP2F - Revised
June 2014)

Fixes: 6e58b8f1daaf1a ("ARM: dts: DRA7: Add the dts files for dra7 SoC and dra7-evm board")
Signed-off-by: Nishanth Menon <nm@ti.com>
Tested-by: Felipe Balbi <balbi@ti.com>
Acked-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

diff --git a/include/dt-bindings/pinctrl/dra.h b/include/dt-bindings/pinctrl/dra.h
index 002a2855c046c7a59e77b914120367728b310e1d..3d33794e4f3edd75950e58cb7d5c49f69e33795b 100644 (file)
--- a/include/dt-bindings/pinctrl/dra.h
+++ b/include/dt-bindings/pinctrl/dra.h
@@ -30,7 +30,8 @@
 #define MUX_MODE14     0xe
 #define MUX_MODE15     0xf
 
-#define PULL_ENA               (1 << 16)
+#define PULL_ENA               (0 << 16)
+#define PULL_DIS               (1 << 16)
 #define PULL_UP                        (1 << 17)
 #define INPUT_EN               (1 << 18)
 #define SLEWCONTROL            (1 << 19)
@@ -38,10 +39,10 @@
 #define WAKEUP_EVENT           (1 << 25)
 
 /* Active pin states */
-#define PIN_OUTPUT             0
+#define PIN_OUTPUT             (0 | PULL_DIS)
 #define PIN_OUTPUT_PULLUP      (PIN_OUTPUT | PULL_ENA | PULL_UP)
 #define PIN_OUTPUT_PULLDOWN    (PIN_OUTPUT | PULL_ENA)
-#define PIN_INPUT              INPUT_EN
+#define PIN_INPUT              (INPUT_EN | PULL_DIS)
 #define PIN_INPUT_SLEW         (INPUT_EN | SLEWCONTROL)
 #define PIN_INPUT_PULLUP       (PULL_ENA | INPUT_EN | PULL_UP)
 #define PIN_INPUT_PULLDOWN     (PULL_ENA | INPUT_EN)