[MIPS] RB532: Do not define registers that are already defined
authorFlorian Fainelli <florian.fainelli@telecomint.eu>
Tue, 5 Aug 2008 20:24:18 +0000 (22:24 +0200)
committerRalf Baechle <ralf@linux-mips.org>
Tue, 26 Aug 2008 08:10:26 +0000 (09:10 +0100)
Use the register definitions of the MPMC controller from
mach-rc32434/rb.h instead of redefining them.

Signed-off-by: Florian Fainelli <florian.fainelli@telecomint.eu>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
arch/mips/rb532/devices.c

index 44fb0a62877fe2a65f8f673228e04e19aea52db1..82ab395efa337e2eeed09cb20a1380d19d1dbafa 100644 (file)
@@ -49,8 +49,6 @@
 #define GPIO_ALE (1 << 0x0a)
 #define GPIO_CLE (1 << 0x0b)
 
-extern char *board_type;
-
 static struct resource korina_dev0_res[] = {
        {
                .name = "korina_regs",
@@ -265,14 +263,6 @@ static void __init parse_mac_addr(char *macstr)
 }
 
 
-/* DEVICE CONTROLLER 1 */
-#define CFG_DC_DEV1    ((void *)0xb8010010)
-#define CFG_DC_DEV2    ((void *)0xb8010020)
-#define CFG_DC_DEVBASE    0x0
-#define CFG_DC_DEVMASK    0x4
-#define CFG_DC_DEVC       0x8
-#define CFG_DC_DEVTC      0xC
-
 /* NAND definitions */
 #define NAND_CHIP_DELAY        25
 
@@ -301,16 +291,16 @@ static void __init rb532_nand_setup(void)
 static int __init plat_setup_devices(void)
 {
        /* Look for the CF card reader */
-       if (!readl(CFG_DC_DEV1 + CFG_DC_DEVMASK))
+       if (!readl(IDT434_REG_BASE + DEV1MASK))
                rb532_devs[1] = NULL;
        else {
                cf_slot0_res[0].start =
-                   readl(CFG_DC_DEV1 + CFG_DC_DEVBASE);
+                   readl(IDT434_REG_BASE + DEV1BASE);
                cf_slot0_res[0].end = cf_slot0_res[0].start + 0x1000;
        }
 
        /* Read the NAND resources from the device controller */
-       nand_slot0_res[0].start = readl(CFG_DC_DEV2 + CFG_DC_DEVBASE);
+       nand_slot0_res[0].start = readl(IDT434_REG_BASE + DEV2BASE);
        nand_slot0_res[0].end = nand_slot0_res[0].start + 0x1000;
 
        /* Initialise the NAND device */