#include <linux/interrupt.h>
#include <linux/leds.h>
#include <linux/platform_device.h>
+ #include <linux/regulator/consumer.h>
+ #include <linux/regulator/fixed.h>
+ #include <linux/regulator/machine.h>
#include <linux/serial_8250.h>
#include <linux/export.h>
+#include <linux/omapfb.h>
+#include <linux/io.h>
#include <media/soc_camera.h>
#include <plat/mux.h>
#include <plat/usb.h>
#include <plat/board.h>
-#include "common.h"
-#include <mach/camera.h>
+#include <mach/hardware.h>
#include <mach/ams-delta-fiq.h>
+#include <mach/camera.h>
+
+#include "iomap.h"
+#include "common.h"
- static u8 ams_delta_latch1_reg;
- static u16 ams_delta_latch2_reg;
-
static const unsigned int ams_delta_keymap[] = {
KEY(0, 0, KEY_F1), /* Advert */
.pins[0] = 2,
};
-static struct omap_board_config_kernel ams_delta_config[] __initdata = {
- { OMAP_TAG_LCD, &ams_delta_lcd_config },
-};
-
+ #define LATCH1_GPIO_BASE 232
+ #define LATCH1_NGPIO 8
+
+ static struct resource latch1_resources[] = {
+ [0] = {
+ .name = "dat",
+ .start = LATCH1_PHYS,
+ .end = LATCH1_PHYS + (LATCH1_NGPIO - 1) / 8,
+ .flags = IORESOURCE_MEM,
+ },
+ };
+
+ static struct bgpio_pdata latch1_pdata = {
+ .base = LATCH1_GPIO_BASE,
+ .ngpio = LATCH1_NGPIO,
+ };
+
+ static struct platform_device latch1_gpio_device = {
+ .name = "basic-mmio-gpio",
+ .id = 0,
+ .resource = latch1_resources,
+ .num_resources = ARRAY_SIZE(latch1_resources),
+ .dev = {
+ .platform_data = &latch1_pdata,
+ },
+ };
+
+ static struct resource latch2_resources[] = {
+ [0] = {
+ .name = "dat",
+ .start = LATCH2_PHYS,
+ .end = LATCH2_PHYS + (AMS_DELTA_LATCH2_NGPIO - 1) / 8,
+ .flags = IORESOURCE_MEM,
+ },
+ };
+
+ static struct bgpio_pdata latch2_pdata = {
+ .base = AMS_DELTA_LATCH2_GPIO_BASE,
+ .ngpio = AMS_DELTA_LATCH2_NGPIO,
+ };
+
+ static struct platform_device latch2_gpio_device = {
+ .name = "basic-mmio-gpio",
+ .id = 1,
+ .resource = latch2_resources,
+ .num_resources = ARRAY_SIZE(latch2_resources),
+ .dev = {
+ .platform_data = &latch2_pdata,
+ },
+ };
+
+ static const struct gpio latch_gpios[] __initconst = {
+ {
+ .gpio = LATCH1_GPIO_BASE + 6,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "dockit1",
+ },
+ {
+ .gpio = LATCH1_GPIO_BASE + 7,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "dockit2",
+ },
+ {
+ .gpio = AMS_DELTA_GPIO_PIN_SCARD_RSTIN,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "scard_rstin",
+ },
+ {
+ .gpio = AMS_DELTA_GPIO_PIN_SCARD_CMDVCC,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "scard_cmdvcc",
+ },
+ {
+ .gpio = AMS_DELTA_GPIO_PIN_MODEM_CODEC,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "modem_codec",
+ },
+ {
+ .gpio = AMS_DELTA_LATCH2_GPIO_BASE + 14,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "hookflash1",
+ },
+ {
+ .gpio = AMS_DELTA_LATCH2_GPIO_BASE + 15,
+ .flags = GPIOF_OUT_INIT_LOW,
+ .label = "hookflash2",
+ },
+ };
+
+ static struct regulator_consumer_supply modem_nreset_consumers[] = {
+ REGULATOR_SUPPLY("RESET#", "serial8250.1"),
+ REGULATOR_SUPPLY("POR", "cx20442-codec"),
+ };
+
+ static struct regulator_init_data modem_nreset_data = {
+ .constraints = {
+ .valid_ops_mask = REGULATOR_CHANGE_STATUS,
+ .boot_on = 1,
+ },
+ .num_consumer_supplies = ARRAY_SIZE(modem_nreset_consumers),
+ .consumer_supplies = modem_nreset_consumers,
+ };
+
+ static struct fixed_voltage_config modem_nreset_config = {
+ .supply_name = "modem_nreset",
+ .microvolts = 3300000,
+ .gpio = AMS_DELTA_GPIO_PIN_MODEM_NRESET,
+ .startup_delay = 25000,
+ .enable_high = 1,
+ .enabled_at_boot = 1,
+ .init_data = &modem_nreset_data,
+ };
+
+ static struct platform_device modem_nreset_device = {
+ .name = "reg-fixed-voltage",
+ .id = -1,
+ .dev = {
+ .platform_data = &modem_nreset_config,
+ },
+ };
+
+ struct modem_private_data {
+ struct regulator *regulator;
+ };
+
+ static struct modem_private_data modem_priv;
+
+ void ams_delta_latch_write(int base, int ngpio, u16 mask, u16 value)
+ {
+ int bit = 0;
+ u16 bitpos = 1 << bit;
+
+ for (; bit < ngpio; bit++, bitpos = bitpos << 1) {
+ if (!(mask & bitpos))
+ continue;
+ else
+ gpio_set_value(base + bit, (value & bitpos) != 0);
+ }
+ }
+ EXPORT_SYMBOL(ams_delta_latch_write);
+
static struct resource ams_delta_nand_resources[] = {
[0] = {
.start = OMAP1_MPUIO_BASE,
ams_delta_init_fiq();
omap_writew(omap_readw(ARM_RSTCT1) | 0x0004, ARM_RSTCT1);
+
+ omapfb_set_lcd_config(&ams_delta_lcd_config);
}
+ static void modem_pm(struct uart_port *port, unsigned int state, unsigned old)
+ {
+ struct modem_private_data *priv = port->private_data;
+
+ if (IS_ERR(priv->regulator))
+ return;
+
+ if (state == old)
+ return;
+
+ if (state == 0)
+ regulator_enable(priv->regulator);
+ else if (old == 0)
+ regulator_disable(priv->regulator);
+ }
+
static struct plat_serial8250_port ams_delta_modem_ports[] = {
{
- .membase = IOMEM(AMS_DELTA_MODEM_VIRT),
- .mapbase = AMS_DELTA_MODEM_PHYS,
+ .membase = IOMEM(MODEM_VIRT),
+ .mapbase = MODEM_PHYS,
.irq = -EINVAL, /* changed later */
.flags = UPF_BOOT_AUTOCONF,
.irqflags = IRQF_TRIGGER_RISING,
.max_width = 4,
.cd_type = S3C_SDHCI_CD_INTERNAL,
.cfg_gpio = crag6410_cfg_sdhci0,
+ .host_caps = MMC_CAP_POWER_OFF_CARD,
+ };
+
+ static const struct gpio_led gpio_leds[] = {
+ {
+ .name = "d13:green:",
+ .gpio = MMGPIO_GPIO_BASE + 0,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d14:green:",
+ .gpio = MMGPIO_GPIO_BASE + 1,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d15:green:",
+ .gpio = MMGPIO_GPIO_BASE + 2,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d16:green:",
+ .gpio = MMGPIO_GPIO_BASE + 3,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d17:green:",
+ .gpio = MMGPIO_GPIO_BASE + 4,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d18:green:",
+ .gpio = MMGPIO_GPIO_BASE + 5,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d19:green:",
+ .gpio = MMGPIO_GPIO_BASE + 6,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ {
+ .name = "d20:green:",
+ .gpio = MMGPIO_GPIO_BASE + 7,
+ .default_state = LEDS_GPIO_DEFSTATE_ON,
+ },
+ };
+
+ static const struct gpio_led_platform_data gpio_leds_pdata = {
+ .leds = gpio_leds,
+ .num_leds = ARRAY_SIZE(gpio_leds),
};
+static struct s3c_hsotg_plat crag6410_hsotg_pdata;
+
static void __init crag6410_machine_init(void)
{
/* Open drain IRQs need pullups */
projects / GitHub / LineageOS / android_kernel_samsung_universal7580.git / commitdiff