staging: comedi: s626: remove 'IsBoardRevA' comment

IsBoardRevA is not defined in the driver. Remove the comment
about it.

Signed-off-by: H Hartley Sweeten <hsweeten@visionengravers.com>
Cc: Ian Abbott <abbotti@mev.co.uk>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/staging/comedi/drivers/s626.c b/drivers/staging/comedi/drivers/s626.c
index 4315892740c994bb51fa013b3b45521df8e0a37e..e67e1299d6041b20559ce32de4c2f0426e7b7ae3 100644 (file)
--- a/drivers/staging/comedi/drivers/s626.c
+++ b/drivers/staging/comedi/drivers/s626.c
@@ -2488,29 +2488,8 @@ static void s626_initialize(struct comedi_device *dev)
        /*  Init GPIO so that ADC Start* is negated. */
        WR7146(P_GPIO, GPIO_BASE | GPIO1_HI);
 
-       /* IsBoardRevA is a boolean that indicates whether the board is RevA.
-        *
-        * VERSION 2.01 CHANGE: REV A & B BOARDS NOW SUPPORTED BY DYNAMIC
-        * EEPROM ADDRESS SELECTION.  Initialize the I2C interface, which
-        * is used to access the onboard serial EEPROM.  The EEPROM's I2C
-        * DeviceAddress is hardwired to a value that is dependent on the
-        * 626 board revision.  On all board revisions, the EEPROM stores
-        * TrimDAC calibration constants for analog I/O.  On RevB and
-        * higher boards, the DeviceAddress is hardwired to 0 to enable
-        * the EEPROM to also store the PCI SubVendorID and SubDeviceID;
-        * this is the address at which the SAA7146 expects a
-        * configuration EEPROM to reside.  On RevA boards, the EEPROM
-        * device address, which is hardwired to 4, prevents the SAA7146
-        * from retrieving PCI sub-IDs, so the SAA7146 uses its built-in
-        * default values, instead.
-        */
-
-       /*     devpriv->I2Cards= IsBoardRevA ? 0xA8 : 0xA0; // Set I2C EEPROM */
-       /*  DeviceType (0xA0) */
-       /*  and DeviceAddress<<1. */
-
-       devpriv->I2CAdrs = 0xA0;        /*  I2C device address for onboard */
-       /*  eeprom(revb) */
+       /* I2C device address for onboard eeprom (revb) */
+       devpriv->I2CAdrs = 0xA0;
 
        /*  Issue an I2C ABORT command to halt any I2C operation in */
        /* progress and reset BUSY flag. */