#include <linux/interrupt.h>
#include <linux/ioport.h>
#include <linux/in.h>
+#include <linux/jiffies.h>
#include <linux/skbuff.h>
#include <linux/spinlock.h>
#include <linux/string.h>
static int __init
wait_eeprom_ready(struct net_device *dev)
{
- int timeout = jiffies;
+ unsigned long timeout = jiffies;
/* check to see if the EEPROM is ready,
* a timeout is used just in case EEPROM is ready when
* SI_BUSY in the PP_SelfST is clear
*/
while (readreg(dev, PP_SelfST) & SI_BUSY)
- if (jiffies - timeout >= 40)
+ if (time_after_eq(jiffies, timeout + 40))
return -1;
return 0;
}
{
struct net_local *lp = netdev_priv(dev);
unsigned int selfcontrol;
- int timenow = jiffies;
+ unsigned long timenow = jiffies;
/* control the DC to DC convertor in the SelfControl register.
* Note: This is hooked up to a general purpose pin, might not
* always be a DC to DC convertor.
writereg(dev, PP_SelfCTL, selfcontrol);
/* Wait for the DC/DC converter to power up - 500ms */
- while (jiffies - timenow < HZ)
+ while (time_before(jiffies, timenow + HZ))
;
}
0, 0, /* DSAP=0 & SSAP=0 fields */
0xf3, 0 /* Control (Test Req + P bit set) */
};
- long timenow = jiffies;
+ unsigned long timenow = jiffies;
writereg(dev, PP_LineCTL, readreg(dev, PP_LineCTL) | SERIAL_TX_ON);
iowrite16(ETH_ZLEN, lp->virt_addr + TX_LEN_PORT);
/* Test to see if the chip has allocated memory for the packet */
- while (jiffies - timenow < 5)
+ while (time_before(jiffies, timenow + 5))
if (readreg(dev, PP_BusST) & READY_FOR_TX_NOW)
break;
- if (jiffies - timenow >= 5)
+ if (time_after_eq(jiffies, timenow + 5))
return 0; /* this shouldn't happen */
/* Write the contents of the packet */
cs89_dbg(1, debug, "Sending test packet ");
/* wait a couple of jiffies for packet to be received */
- for (timenow = jiffies; jiffies - timenow < 3;)
+ for (timenow = jiffies; time_before(jiffies, timenow + 3);)
;
if ((readreg(dev, PP_TxEvent) & TX_SEND_OK_BITS) == TX_OK) {
cs89_dbg(1, cont, "succeeded\n");
detect_tp(struct net_device *dev)
{
struct net_local *lp = netdev_priv(dev);
- int timenow = jiffies;
+ unsigned long timenow = jiffies;
int fdx;
cs89_dbg(1, debug, "%s: Attempting TP\n", dev->name);
/* Delay for the hardware to work out if the TP cable is present
* - 150ms
*/
- for (timenow = jiffies; jiffies - timenow < 15;)
+ for (timenow = jiffies; time_before(jiffies, timenow + 15);)
;
if ((readreg(dev, PP_LineST) & LINK_OK) == 0)
return DETECTED_NONE;
if ((lp->auto_neg_cnf & AUTO_NEG_BITS) == AUTO_NEG_ENABLE) {
pr_info("%s: negotiating duplex...\n", dev->name);
while (readreg(dev, PP_AutoNegST) & AUTO_NEG_BUSY) {
- if (jiffies - timenow > 4000) {
+ if (time_after(jiffies, timenow + 4000)) {
pr_err("**** Full / half duplex auto-negotiation timed out ****\n");
break;
}
{
#if !defined(CONFIG_MACH_MX31ADS)
struct net_local *lp = netdev_priv(dev);
- int reset_start_time;
+ unsigned long reset_start_time;
writereg(dev, PP_SelfCTL, readreg(dev, PP_SelfCTL) | POWER_ON_RESET);
/* Wait until the chip is reset */
reset_start_time = jiffies;
while ((readreg(dev, PP_SelfST) & INIT_DONE) == 0 &&
- jiffies - reset_start_time < 2)
+ time_before(jiffies, reset_start_time + 2))
;
#endif /* !CONFIG_MACH_MX31ADS */
}