To support network namespace the driver must assure all created
network interfaces are in the same namespace as the wiphy instance
and flag the support using WIPHY_FLAG_NETNS_OK.
Verified using two terminals:
Terminal 1 Terminal 2
-------------------------- ---------------------------------
# ip netns add brcm-wifi # iw dev
phy#0
Interface wlan3
ifindex 11
wdev 0x1
# ip netns exec brcm-wifi bash
# iw dev
# echo $$
20337 # iw phy0 set netns 20337
# iw dev
phy#0
Interface wlan3
ifindex 11
wdev 0x2
# iw phy0 interface add wl3.ap type __ap
# iw dev
phy#0
Interface wl3.ap
ifindex 2
wdev 0x3
Interface wlan3
ifindex 11
wdev 0x2
# iw dev
# iw phy0 set netns 1
# iw dev
# iw dev
phy#0
Interface wl3.ap
ifindex 2
wdev 0x5
Interface wlan3
ifindex 11
wdev 0x4
Note:
increasing wdev identifier above indicates issue in
cfg80211 which is addressed separately.
Tested-by: Mark Asselstine <mark.asselstine@windriver.com>
Signed-off-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Reviewed-by: Franky Lin <franky.lin@broadcom.com>
Reviewed-by: Hante Meuleman <hante.meuleman@broadcom.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
BIT(NL80211_BSS_SELECT_ATTR_BAND_PREF) |
BIT(NL80211_BSS_SELECT_ATTR_RSSI_ADJUST);
- wiphy->flags |= WIPHY_FLAG_PS_ON_BY_DEFAULT |
+ wiphy->flags |= WIPHY_FLAG_NETNS_OK |
+ WIPHY_FLAG_PS_ON_BY_DEFAULT |
WIPHY_FLAG_OFFCHAN_TX |
WIPHY_FLAG_HAS_REMAIN_ON_CHANNEL;
if (brcmf_feat_is_enabled(ifp, BRCMF_FEAT_TDLS))
ndev->needed_headroom += drvr->hdrlen;
ndev->ethtool_ops = &brcmf_ethtool_ops;
- /* set the mac address */
+ /* set the mac address & netns */
memcpy(ndev->dev_addr, ifp->mac_addr, ETH_ALEN);
+ dev_net_set(ndev, wiphy_net(cfg_to_wiphy(drvr->config)));
INIT_WORK(&ifp->multicast_work, _brcmf_set_multicast_list);
INIT_WORK(&ifp->ndoffload_work, _brcmf_update_ndtable);