return retval;
}
+void usb_enable_root_hub_irq (struct usb_bus *bus)
+{
+ struct usb_hcd *hcd;
+
+ hcd = container_of (bus, struct usb_hcd, self);
+ if (hcd->driver->hub_irq_enable && hcd->state != HC_STATE_HALT)
+ hcd->driver->hub_irq_enable (hcd);
+}
+
/*-------------------------------------------------------------------------*/
int (*bus_suspend)(struct usb_hcd *);
int (*bus_resume)(struct usb_hcd *);
int (*start_port_reset)(struct usb_hcd *, unsigned port_num);
+ void (*hub_irq_enable)(struct usb_hcd *);
+ /* Needed only if port-change IRQs are level-triggered */
/* force handover of high-speed port to full-speed companion */
void (*relinquish_port)(struct usb_hcd *, int);
}
clear_bit(port1, hub->busy_bits);
+ if (!hub->hdev->parent && !hub->busy_bits[0])
+ usb_enable_root_hub_irq(hub->hdev->bus);
if (status == 0)
status = finish_port_resume(udev);
hub->activating = 0;
+ /* If this is a root hub, tell the HCD it's okay to
+ * re-enable port-change interrupts now. */
+ if (!hdev->parent && !hub->busy_bits[0])
+ usb_enable_root_hub_irq(hdev->bus);
+
loop_autopm:
/* Allow autosuspend if we're not going to run again */
if (list_empty(&hub->event_list))
break;
}
clear_bit(port1, parent_hub->busy_bits);
+ if (!parent_hdev->parent && !parent_hub->busy_bits[0])
+ usb_enable_root_hub_irq(parent_hdev->bus);
if (ret < 0)
goto re_enumerate;
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
.get_frame_number = ohci_get_frame,
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
/*-------------------------------------------------------------------------*/
+/* hcd->hub_irq_enable() */
+static void ohci_rhsc_enable (struct usb_hcd *hcd)
+{
+ struct ohci_hcd *ohci = hcd_to_ohci (hcd);
+
+ spin_lock_irq(&ohci->lock);
+ if (!ohci->autostop)
+ del_timer(&hcd->rh_timer); /* Prevent next poll */
+ ohci_writel(ohci, OHCI_INTR_RHSC, &ohci->regs->intrenable);
+ spin_unlock_irq(&ohci->lock);
+}
+
#define OHCI_SCHED_ENABLES \
(OHCI_CTRL_CLE|OHCI_CTRL_BLE|OHCI_CTRL_PLE|OHCI_CTRL_IE)
int any_connected)
{
int poll_rh = 1;
- int rhsc;
- rhsc = ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC;
switch (ohci->hc_control & OHCI_CTRL_HCFS) {
case OHCI_USB_OPER:
- /* If no status changes are pending, enable status-change
- * interrupts.
- */
- if (!rhsc && !changed) {
- rhsc = OHCI_INTR_RHSC;
- ohci_writel(ohci, rhsc, &ohci->regs->intrenable);
- }
-
- /* Keep on polling until we know a device is connected
- * and RHSC is enabled, or until we autostop.
- */
+ /* keep on polling until we know a device is connected
+ * and RHSC is enabled */
if (!ohci->autostop) {
if (any_connected ||
!device_may_wakeup(&ohci_to_hcd(ohci)
->self.root_hub->dev)) {
- if (rhsc)
+ if (ohci_readl(ohci, &ohci->regs->intrenable) &
+ OHCI_INTR_RHSC)
poll_rh = 0;
} else {
ohci->autostop = 1;
ohci->autostop = 0;
ohci->next_statechange = jiffies +
STATECHANGE_DELAY;
- } else if (rhsc && time_after_eq(jiffies,
+ } else if (time_after_eq(jiffies,
ohci->next_statechange)
&& !ohci->ed_rm_list
&& !(ohci->hc_control &
OHCI_SCHED_ENABLES)) {
ohci_rh_suspend(ohci, 1);
- poll_rh = 0;
}
}
break;
else
usb_hcd_resume_root_hub(ohci_to_hcd(ohci));
} else {
- if (!rhsc && (ohci->autostop ||
- ohci_to_hcd(ohci)->self.root_hub->
- do_remote_wakeup))
- ohci_writel(ohci, OHCI_INTR_RHSC,
- &ohci->regs->intrenable);
-
/* everything is idle, no need for polling */
poll_rh = 0;
}
static int ohci_root_hub_state_changes(struct ohci_hcd *ohci, int changed,
int any_connected)
{
- /* If RHSC is enabled, don't poll */
- if (ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC)
- return 0;
+ int poll_rh = 1;
- /* If no status changes are pending, enable status-change interrupts */
- if (!changed) {
- ohci_writel(ohci, OHCI_INTR_RHSC, &ohci->regs->intrenable);
- return 0;
- }
- return 1;
+ /* keep on polling until RHSC is enabled */
+ if (ohci_readl(ohci, &ohci->regs->intrenable) & OHCI_INTR_RHSC)
+ poll_rh = 0;
+ return poll_rh;
}
#endif /* CONFIG_PM */
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
.get_frame_number = ohci_get_frame,
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
.start_port_reset = ohci_start_port_reset,
#if defined(CONFIG_PM)
.bus_suspend = ohci_bus_suspend,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_s3c2410_hub_status_data,
.hub_control = ohci_s3c2410_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
*/
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
.hub_status_data = ohci_hub_status_data,
.hub_control = ohci_hub_control,
+ .hub_irq_enable = ohci_rhsc_enable,
#ifdef CONFIG_PM
.bus_suspend = ohci_bus_suspend,
.bus_resume = ohci_bus_resume,
return 0;
}
+static void u132_hub_irq_enable(struct usb_hcd *hcd)
+{
+ struct u132 *u132 = hcd_to_u132(hcd);
+ if (u132->going > 1) {
+ dev_err(&u132->platform_dev->dev, "device has been removed %d\n"
+ , u132->going);
+ } else if (u132->going > 0)
+ dev_err(&u132->platform_dev->dev, "device is being removed\n");
+}
+
#ifdef CONFIG_PM
static int u132_bus_suspend(struct usb_hcd *hcd)
.bus_suspend = u132_bus_suspend,
.bus_resume = u132_bus_resume,
.start_port_reset = u132_start_port_reset,
+ .hub_irq_enable = u132_hub_irq_enable,
};
/*