drivers/w1/slaves/Kconfig

   1 #
   2 # 1-wire slaves configuration
   3 #
   4
   5 menu "1-wire Slaves"
   6
   7 config W1_SLAVE_THERM
   8         tristate "Thermal family implementation"
   9         help
  10           Say Y here if you want to connect 1-wire thermal sensors to your
  11           wire.
  12
  13 config W1_SLAVE_SMEM
  14         tristate "Simple 64bit memory family implementation"
  15         help
  16           Say Y here if you want to connect 1-wire
  17           simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire.
  18
  19 config W1_SLAVE_DS2423
  20         tristate "Counter 1-wire device (DS2423)"
  21         select CRC16
  22         help
  23           If you enable this you can read the counter values available
  24           in the DS2423 chipset from the w1_slave file under the
  25           sys file system.
  26
  27           Say Y here if you want to use a 1-wire
  28           counter family device (DS2423).
  29
  30 config W1_SLAVE_DS2431
  31         tristate "1kb EEPROM family support (DS2431)"
  32         help
  33           Say Y here if you want to use a 1-wire
  34           1kb EEPROM family device (DS2431)
  35
  36 config W1_SLAVE_DS2433
  37         tristate "4kb EEPROM family support (DS2433)"
  38         help
  39           Say Y here if you want to use a 1-wire
  40           4kb EEPROM family device (DS2433).
  41
  42 config W1_SLAVE_DS2433_CRC
  43         bool "Protect DS2433 data with a CRC16"
  44         depends on W1_SLAVE_DS2433
  45         select CRC16
  46         help
  47           Say Y here to protect DS2433 data with a CRC16.
  48           Each block has 30 bytes of data and a two byte CRC16.
  49           Full block writes are only allowed if the CRC is valid.
  50
  51 config W1_SLAVE_DS2760
  52         tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)"
  53         depends on W1
  54         help
  55           If you enable this you will have the DS2760 battery monitor
  56           chip support.
  57
  58           The battery monitor chip is used in many batteries/devices
  59           as the one who is responsible for charging/discharging/monitoring
  60           Li+ batteries.
  61
  62           If you are unsure, say N.
  63
  64 config W1_SLAVE_BQ27000
  65         tristate "BQ27000 slave support"
  66         depends on W1
  67         help
  68           Say Y here if you want to use a hdq
  69           bq27000 slave support.
  70
  71 endmenu