drivers/net/ethernet/cadence/Kconfig

   1 #
   2 # Atmel device configuration
   3 #
   4
   5 config HAVE_NET_MACB
   6         bool
   7
   8 config NET_CADENCE
   9         bool "Cadence devices"
  10         default y
  11         depends on HAVE_NET_MACB || (ARM && ARCH_AT91RM9200)
  12         ---help---
  13           If you have a network (Ethernet) card belonging to this class, say Y.
  14           Make sure you know the name of your card. Read the Ethernet-HOWTO,
  15           available from <http://www.tldp.org/docs.html#howto>.
  16
  17           If unsure, say Y.
  18
  19           Note that the answer to this question doesn't directly affect the
  20           kernel: saying N will just cause the configurator to skip all
  21           the remaining Atmel network card questions. If you say Y, you will be
  22           asked for your specific card in the following questions.
  23
  24 if NET_CADENCE
  25
  26 config ARM_AT91_ETHER
  27         tristate "AT91RM9200 Ethernet support"
  28         depends on ARM && ARCH_AT91RM9200
  29         select NET_CORE
  30         select MII
  31         ---help---
  32           If you wish to compile a kernel for the AT91RM9200 and enable
  33           ethernet support, then you should always answer Y to this.
  34
  35 config MACB
  36         tristate "Cadence MACB/GEM support"
  37         depends on HAVE_NET_MACB
  38         select PHYLIB
  39         ---help---
  40           The Cadence MACB ethernet interface is found on many Atmel AT32 and
  41           AT91 parts.  This driver also supports the Cadence GEM (Gigabit
  42           Ethernet MAC found in some ARM SoC devices).  Note: the Gigabit mode
  43           is not yet supported.  Say Y to include support for the MACB/GEM chip.
  44
  45           To compile this driver as a module, choose M here: the module
  46           will be called macb.
  47
  48 endif # NET_CADENCE